Join 3reef now to remove this notice and enjoy 3reef content with less ads. 3reef membership is free.
Got it. Ya... blow into the air line and see if air makes it to the pump. Regardless.... just about all skimmer pumps are modified water pumps....
+1 Return pumps are not for flow.... they are to move water from the display tank to the sump and back to the tank. Powerheads are for flow.
How much do you plan on getting for a skimmer that does not work? The venturi creates a low pressure area that draws air in. If there are no...
Seems to me that if you read the thread on N and P bio pellets... the originals... that many found that they needed strong flow and motion like you...
So check the air line and venturi to make sure they are clear.
Are you open to a sump at all? What is your tank going to be for? Not a big fan of canisters just because of cost and maintenance.
I haven't talked to Warner in a while and do not know if he sold the rights or just does not make them or what. And sorry, I just meant if it is...
Sure. I was mainly just talking about the nitrate load. The bacteria and algae need to grow more to handle it. If nitrates were being handled by...
You need to give your system time to get adjusted to the new load. Sock don't remove nitrates. Bacteria and algae do. So if you have a refugium with...
Some thing is wrong... skimmers do not "stop" making bubbles after a year for no reason. The Super skimmers are not the best, but they do make...
The skimmer is basically a mechanical filter and will sort of pick up the excess of no sock. Doubt it removes as much as the sock since they are...
Well it's a clone of the Warner Marine Red Demon which is just wrong if you ask me. Yes it is an improvement over stock.... about 20%... but same as...
I did. Then I started using bio pellets. Then I took my tank down about 6 months ago cause I'm moving.
The question is with such a small fish load why are your nitrates so high and you need a coil. How much DIY LR do you have? I wonder if your DIY LR...
Ya, just to be clear I don't see any reason it would matter how you ran the UV. Just give it some clean water off the return or reactor. Go by what...
You can do anything really. So are you running a "canister filter" in your sump or is the sump new to get rid of the canister? Ya, canisters are...
You need to run it off the return section and back to it. Just separate the two a bit. You can just set the reactor in the return section or hang it...
I ran my Mag 7 wide open, but had the water level where recommended at the junction. All that really matters is that a higher water level will give...
I have to admit... I never understood the point of Chemi pure. The benefits of carbon are well documented but you can get that anywhere. Plus it has...
You say your parameters are good, but what does that mean? The only reason to do water changes is to remove something or to replace something. There...
Separate names with a comma.