Search Results

to remove this notice and enjoy 3reef content with less ads. 3reef membership is free.

Search Again
Page 1 of 10
  1. Kevin_E
    Post

    How to adjust skimmer? (Reef Octopus NWB-150)

    I'll have to mess with it tomorrow. Anytime I try and raise it into 6-8", it stops pumping as the water level gets below the inner tube. Right now...
    Post by: Kevin_E, Oct 31, 2013 in forum: Protein Skimmers
  2. Kevin_E
    Post

    SPS wish list

    Pics didn't come through. :( Edit: NM
    Post by: Kevin_E, Oct 31, 2013 in forum: SPS Corals
  3. Kevin_E
    Post

    Dosing pumps and solution question

    After some more research I have concluded that this pump is geared more for an ATO system. 53 ml/m is too fast.
    Post by: Kevin_E, Oct 31, 2013 in forum: Water Chemistry
  4. Kevin_E
    Post

    How to adjust skimmer? (Reef Octopus NWB-150)

    Also, how deep should it sit in water and should that side tube be under water?
    Post by: Kevin_E, Oct 31, 2013 in forum: Protein Skimmers
  5. Kevin_E
    Thread

    How to adjust skimmer? (Reef Octopus NWB-150)

    I'm not sure how the "open" and "closed" function works. Nothing seems to happen.
    Thread by: Kevin_E, Oct 31, 2013, 7 replies, in forum: Protein Skimmers
  6. Kevin_E
    Post

    Dosing pumps and solution question

    How do you all figure out your dosing mixture? Maybe I am making this too complicated?
    Post by: Kevin_E, Oct 31, 2013 in forum: Water Chemistry
  7. Kevin_E
    Post

    Dosing pumps and solution question

    Sorry, the list the flow rate at 0.8 GPH or 50 ml/min. Pump rate= 0.8 gal/hr 1.25 hours= 1 gallon 1.25 hours/30 days (1 month supply of...
    Post by: Kevin_E, Oct 31, 2013 in forum: Water Chemistry
  8. Kevin_E
    Post

    Adding corals to a tank

    I like to put some super glue on both the frag side and rock side of epoxy.
    Post by: Kevin_E, Oct 30, 2013 in forum: Coral
  9. Kevin_E
    Post

    Adding corals to a tank

    I cut the nipple off of the plug and contour down the the rock with epoxy. It hides the plug and will grow over it in time. I also like to find frags...
    Post by: Kevin_E, Oct 30, 2013 in forum: Coral
  10. Kevin_E
    Post

    Dosing pumps and solution question

    I know there are some mad scientists out there. Crunch some numbers!;D
    Post by: Kevin_E, Oct 30, 2013 in forum: Water Chemistry
  11. Kevin_E
    Post

    Dosing pumps and solution question

    Is this right? Pump rate= 0.8 gal/hr 1.25 hours= 1 gallon 1.25 hours/30 days (1 month supply of solution)= Dosing for 2.5 min/day Tank use=...
    Post by: Kevin_E, Oct 30, 2013 in forum: Water Chemistry
  12. Kevin_E
    Thread

    Dosing pumps and solution question

    My system uses 0.117 meq/l or 5.85 ppm or alkalinity per day. This comes to 0.275 teaspoons per day. I have been adding this to my ATO bucket that...
    Thread by: Kevin_E, Oct 30, 2013, 7 replies, in forum: Water Chemistry
  13. Kevin_E
    Post

    My Valydia, Update- Doing awesome, new pic today 1/25/14

    Any better pictures? cleaner? Could be alk. swings if it isn't growth tips. Have you every noticed growth tips? If not, it's likely not it. I had...
    Post by: Kevin_E, Oct 30, 2013 in forum: SPS Corals
  14. Kevin_E
    Post

    No PE but there is growth (Montipora digitata) *Update last page

    Some good looking growth too. Encrusting away.
    Post by: Kevin_E, Oct 30, 2013 in forum: SPS Corals
  15. Kevin_E
    Post

    What are these?

    Pineapple *sponge*. haha Don't try eating them.
    Post by: Kevin_E, Oct 30, 2013 in forum: ID This!
  16. Kevin_E
    Post

    Red Planet (1-24-14 growth pics)

    phosphates came in at 0.015 on the ULR Hannah checker last night (5 ppb phosphorus), so it's fine. My nitrates are always undetectable. My other...
    Post by: Kevin_E, Oct 29, 2013 in forum: SPS Corals
  17. Kevin_E
    Post

    Red Planet (1-24-14 growth pics)

    Unfortunately, I can't get either to come forth. There was a breif moment several weeks back where I saw a green hue with a pink tip or two coming...
    Post by: Kevin_E, Oct 29, 2013 in forum: SPS Corals
  18. Kevin_E
    Post

    Red Planet (1-24-14 growth pics)

    Yeah, mine was showing hints of green before washing out again. The only time it every showed red was when I first introduces it. I would estimate...
    Post by: Kevin_E, Oct 29, 2013 in forum: SPS Corals
  19. Kevin_E
    Post

    Red Planet (1-24-14 growth pics)

    250 watt metal halide. Phoenix bulb.
    Post by: Kevin_E, Oct 29, 2013 in forum: SPS Corals
  20. Kevin_E
    Post

    Red Planet (1-24-14 growth pics)

    A little concerned with the color. It's light brown and doesn't seem to want to color up any. I am wondering if it is too low in the tank.
    Post by: Kevin_E, Oct 29, 2013 in forum: SPS Corals
Showing results 1 to 20 of 190 Next >
Search Again
Page 1 of 10