Calibrating PH probe

Discussion in 'ASAP' started by iReefer, Sep 12, 2011.

to remove this notice and enjoy 3reef content with less ads. 3reef membership is free.

Page 2 of 2
  1. pink4miss

    pink4miss Panda Puffer

    Joined:
    May 11, 2010
    Messages:
    2,115
    Location:
    Bucks County, Pa
    go into the display module and do a restart on the display unit. it could have froze up from trying to calibrate with the cap on and it not getting a reading for so long
     
    pink4miss, Sep 12, 2011
    pink4miss, Sep 12, 2011
    #11

    2. Click Here!

  2. pink4miss

    pink4miss Panda Puffer

    Joined:
    May 11, 2010
    Messages:
    2,115
    Location:
    Bucks County, Pa
    in th display unit go to - system - net set up - restart. the screen will go blank and than pop back up again.

    than retry the ph calibration, as they say to do it. i would also unplug the probe from the unit. in other words start fresh
     
    pink4miss, Sep 12, 2011
    pink4miss, Sep 12, 2011
    #12
  3. pink4miss

    pink4miss Panda Puffer

    Joined:
    May 11, 2010
    Messages:
    2,115
    Location:
    Bucks County, Pa
    sent you a private message
     
    pink4miss, Sep 12, 2011
    pink4miss, Sep 12, 2011
    #13
Page 2 of 2