Search Results

to remove this notice and enjoy 3reef content with less ads. 3reef membership is free.

Search Again
Page 4 of 9
  1. evolved
    Post

    Calling all VorTech owners..

    120 Long (60X18X24) 2 MP40s, running anti-sync, reef crest, 2 dots from full blast I do run them in night mode for 10 hours in the dark....
    Post by: evolved, Jan 9, 2012 in forum: Filters, Pumps, etc..
  2. evolved
    Post

    Water Shimmer Effect Reduction

    There's not much you can do here; shimmer is inherent to any point-light source (LEDs, MHs, etc). What do your optics looks like? Specifically, the...
    Post by: evolved, Jan 9, 2012 in forum: LED Aquarium Lighting
  3. evolved
    Post

    What watt soldering Iron is Best

    Ah, you're thinking of a DMM (digital multi-meter). Yes, you'll need something of this nature to check/set the current. There's an instructional in...
    Post by: evolved, Jan 9, 2012 in forum: LED Aquarium Lighting
  4. evolved
    Post

    Growth of coral

    I suspect a balance issue with the big 3 (Alk, Ca, Mg) as I see no coralline growth (which I'd expect in an established tank). What do you strive to...
    Post by: evolved, Jan 9, 2012 in forum: Coral
  5. evolved
    Post

    wrasse id

    Cirrhilabrus tonozukai (male) is correct; not at all a flasher wrasse.
    Post by: evolved, Jan 9, 2012 in forum: Tropical Fish
  6. evolved
    Post

    Bit stumped...

    Ah, very much so, in that case. All of those guys need it. :D
    Post by: evolved, Jan 8, 2012 in forum: Sand
  7. evolved
    Post

    Bit stumped...

    That's probably fine enough. What type of wrasses do you have in mind? Fairy & Flasher's don't need it, FYI. :)
    Post by: evolved, Jan 8, 2012 in forum: Sand
  8. evolved
    Post

    Satering iron for diy led

    Then I'd expect your voltage to be running around 36V, if you're truely running near an amp at full power (power = voltage * current).
    Post by: evolved, Jan 8, 2012 in forum: LED Aquarium Lighting
  9. evolved
    Post

    Satering iron for diy led

    How many diodes in your sting? 24-48V, depending. SVR1 should be preset from the factory, but I suspect some might be off if Mike told you to...
    Post by: evolved, Jan 8, 2012 in forum: LED Aquarium Lighting
  10. evolved
    Post

    What coral would this be?

    Yes; a species of pavona. Polyps on psammacora are much smaller.
    Post by: evolved, Jan 8, 2012 in forum: ID This!
  11. evolved
    Post

    Satering iron for diy led

    If you messed with SVR1, make sure your driver is still producing the correct voltage. You don't need to touch SVR1; SVR1 is voltage, SVR2 is...
    Post by: evolved, Jan 8, 2012 in forum: LED Aquarium Lighting
  12. evolved
    Post

    Satering iron for diy led

    Soldering iron. http://www.3reef.com/forums/led-aquarium-lighting/what-watt-soldering-iron-best-127689.html
    Post by: evolved, Jan 6, 2012 in forum: LED Aquarium Lighting
  13. evolved
    Post

    Exactly's ZEOvit 90G has reached the end :(

    Devil fish; don't do it. Never will a Pseudocheilinus wrasse be in my DT...
    Post by: evolved, Jan 6, 2012 in forum: Show Off Your Fish Tanks!
  14. evolved
    Post

    Cloudy RO DI Water + Salt mix in New Brute Trashbin

    Sounds like you've figured out what went wrong, and what you need to do. But just to provide the rest of the story, what you were seeing was...
    Post by: evolved, Jan 6, 2012 in forum: Water Chemistry
  15. evolved
    Post

    Will this heat sink work?

    Slightly better, but still far from an efficient heat sink. Start here: Heat sink - Wikipedia, the free encyclopedia
    Post by: evolved, Jan 6, 2012 in forum: LED Aquarium Lighting
  16. evolved
    Post

    Now known Algae - Got ID - Need Fix

    Interesting discussion/discovery... I doubt this would work; you'd deplete the resin in a matter of minutes, plus you'd probably strip some...
    Post by: evolved, Jan 5, 2012 in forum: Algae
  17. evolved
    Post

    Atticus' 75g *Somethings seem to be growing* 12/03/12

    Both look good right now. :) I'm sure you're aware, but the Potter's will probably disappear for a few days. And what about the "other" new fish?...
    Post by: evolved, Jan 4, 2012 in forum: Show Off Your Fish Tanks!
  18. evolved
    Post

    if you have ever been banned from RC

    My local reef club's forum is hosted on RC, and that's the only reason I go there. I pay no attention to any other forums on the site, except for...
    Post by: evolved, Jan 4, 2012 in forum: The Bucket
  19. evolved
    Post

    Everything almost dead.HELP!!!

    Let's start from the beginning... I get the impression you are doing your water changes by adding pure water and salt directly to the tank, and...
    Post by: evolved, Jan 4, 2012 in forum: ASAP
  20. evolved
    Post

    Will this heat sink work?

    That's not even a heat sink.
    Post by: evolved, Jan 4, 2012 in forum: LED Aquarium Lighting
Showing results 61 to 80 of 166 Next >
Search Again
Page 4 of 9