Search Results

to remove this notice and enjoy 3reef content with less ads. 3reef membership is free.

Search Again
Page 3 of 10
  1. AZDesertRat
    Post

    Advice! CO2 off the chart on my well water to RODI

    Yes. You could mount it up higher and let it drain down to the DI then down to storage.
    Post by: AZDesertRat, Jul 16, 2015 in forum: Water Chemistry
  2. AZDesertRat
    Post

    Advice! CO2 off the chart on my well water to RODI

    Spectrapure has instructions on how to construct a degassing tower here: http://spectrapure.com/frequently-asked-questions#calcc02 It does not...
    Post by: AZDesertRat, Jul 16, 2015 in forum: Water Chemistry
  3. AZDesertRat
    Post

    Best water to use?

    You don't stick it in the drain at all, you leave an air gap and let it drip into the drain. Some new washing machine wall drains have a provision...
    Post by: AZDesertRat, Jul 10, 2015 in forum: New To The Hobby
  4. AZDesertRat
    Post

    Best water to use?

    Always follow building and health codes when installing a RO or RO/DI. You should not just stick the waste or brine line down a drain, that is a...
    Post by: AZDesertRat, Jul 9, 2015 in forum: New To The Hobby
  5. AZDesertRat
    Post

    Best water to use?

    Any RO/DI can be used portable or installed semi permanent or permanent. It can be as simple as a screw on faucet adapter, a little more permanent...
    Post by: AZDesertRat, Jul 9, 2015 in forum: New To The Hobby
  6. AZDesertRat
    Post

    Restricting flow on Maxi-jet

    We use the same style push fittings for 100% chlorine gas and high strength chlorine/water solutions and they hold up surprisingly well even under...
    Post by: AZDesertRat, Jun 17, 2015 in forum: Filters, Pumps, etc..
  7. AZDesertRat
    Post

    Restricting flow on Maxi-jet

    The grippers are high grade stainless so will last for years submerged.
    Post by: AZDesertRat, Jun 17, 2015 in forum: Filters, Pumps, etc..
  8. AZDesertRat
    Post

    Restricting flow on Maxi-jet

    In fact, as I think about it, take the MJ to the hardware store with you. If I remember correctly a 1/2"John Guest style tubing fitting slips over...
    Post by: AZDesertRat, Jun 13, 2015 in forum: Filters, Pumps, etc..
  9. AZDesertRat
    Post

    Restricting flow on Maxi-jet

    Install a short piece of 1/2" tubing and a 1/2" ball valve on the outlet of the pump. It will not harm the pump and you can adjust the valve to...
    Post by: AZDesertRat, Jun 12, 2015 in forum: Filters, Pumps, etc..
  10. AZDesertRat
    Post

    Custom Glass Lid for tank Question?

    My neighbor had a wolf eel that would climb out of one tank and into the one sitting next to it. Didn't believe it until we turned the room lights...
    Post by: AZDesertRat, May 5, 2015 in forum: General Reef Topics
  11. AZDesertRat
    Post

    Custom Glass Lid for tank Question?

    My question is why a lid at all? I have not had a covered tank in 30 years and never had any issues other than one yellow watchman goby that went...
    Post by: AZDesertRat, May 5, 2015 in forum: General Reef Topics
  12. AZDesertRat
    Post

    Looking for help from AZ reefers

    Some external pumps run very hot and still transfer heat to the water. Lowering humidity in the house is tough without a dehumidifier. If you vent...
    Post by: AZDesertRat, May 5, 2015 in forum: General Reef Topics
  13. AZDesertRat
    Post

    Looking for help from AZ reefers

    I found the best thing I ever did was switch from MH and VHO lighting which required either a chiller or multiple fans to keep the temperature in...
    Post by: AZDesertRat, May 4, 2015 in forum: General Reef Topics
  14. AZDesertRat
    Post

    Experiences with jebao wavemakers?

    The WP-10 is a good choice. I have two WP-25s in a 5 foot 100G and they can move sand at the far ends so probably way too much for a 25G even turned...
    Post by: AZDesertRat, May 4, 2015 in forum: Filters, Pumps, etc..
  15. AZDesertRat
    Post

    RODI Help

    New saltwater TDS will be over 32,000. Way above the range of the TDS meter.
    Post by: AZDesertRat, Apr 3, 2015 in forum: Filters, Pumps, etc..
  16. AZDesertRat
    Post

    Flow for a 320 Gallon Display Tank

    Check valves are a false sense of security and can and do fail. Remember, it does not have to be a catastropic failure, even a trickle will flood...
    Post by: AZDesertRat, Apr 1, 2015 in forum: Filters, Pumps, etc..
  17. AZDesertRat
    Post

    Flow for a 320 Gallon Display Tank

    I would place the 4 OM outlets near the four upper corners. You do not want to place any return near the bottom or you run the risk of siphoning the...
    Post by: AZDesertRat, Apr 1, 2015 in forum: Filters, Pumps, etc..
  18. AZDesertRat
    Post

    RODI Help

    Here is a simple diagram: http://spectrapure.com/huds/NEW-MO-BPK.pdf and a very elaborate one with all the bells and whistles:...
    Post by: AZDesertRat, Mar 30, 2015 in forum: Filters, Pumps, etc..
  19. AZDesertRat
    Post

    RODI Help

    A RO booster pump fits inline between the sediment and/or carbon block filter and the RO membrane so it is protected by the filter(s). It raises your...
    Post by: AZDesertRat, Mar 30, 2015 in forum: Filters, Pumps, etc..
  20. AZDesertRat
    Post

    RODI Help

    I used to have one on the local reef forum here in AZ but it folded a couple years ago. Been meaning to do another one but haven't had the time....
    Post by: AZDesertRat, Mar 24, 2015 in forum: Filters, Pumps, etc..
Showing results 41 to 60 of 200 Next >
Search Again
Page 3 of 10