Join 3reef now to remove this notice and enjoy 3reef content with less ads. 3reef membership is free.
Filled it up and then shut the power off. This image shows the water level with the power off. The video shows how it will run full. New sump -...
Check to see if the impeller is in good shape. If not you might just need to replace it.
welcome
1" is all I could fit in the pre-drilled holes. 3/4" returns
Welcome to 3reef
One question. On my Durso Standpipes in the overflow should I drill a bigger whole in the top to allow for more water flow. Before the pump was much...
Didn't make it to the top ten. However, the labels up there are there for good reason. Good luck to you all. It was fun can't wait till the next one.
The water level will be 4" inches higher than the bottom of the fuge. Maybe I can cut some pvc to support that front edge of the fuge. can get much...
Here is another pic maybe it will make more sense.
finished my sump/fuge and hooked up my new pump.
Is it gonna be in the form of a poll?
The ATO and the water barrel is next. I will monitor it and see how it flows. I'm worried that if I drain pipe in I will have issues with micro...
The fuge is empty at the moment. I drains off the side and I have to get the water level up higher. The water salinity was so low I didn't want to...
My four year old stand on the ledge and hangs on to the little feeder door to feed the fish. If it's level the weight of the tank and sump will weigh...
I just need some algae for the fuge.
Bought a WYE fitting and ran spa flex from the pump to the WYE then it goes to 3/4 inch Much more flow. I have to raise the salinity again it's...
Sump and new pump is in! So I was fixing the other 55g tank and noticed it was more work than it was worth. So I headed to Craigslist and found one...
:inquisiti:inquisiti:trampolin:trampolin:drummer::drummer: And the winner is?
It really depends on how it was built! However it should hold up just fine. The bottom is most likely sitting on the floor or made out of plywood. if...
My 125G is 40" or 42" on the stand. All I did was make the base a few inches wider by using thick trim around the bottom.
Separate names with a comma.