Join 3reef now to remove this notice and enjoy 3reef content with less ads. 3reef membership is free.
Then try some biological control. With the numbers you have, I would likely do berghias if it were my tank. They take a while to form a large enough...
It really depends on your setup and what you plan to keep. In a FOWLR, you can get away with as low as 5x, or maybe less, depending on the amount of...
The only other option I see for such large quantities is biological control. Berghia nudibranchs, peppermint shrimp, copperbanded butterfly....
Do you have anything covering the top of the tank? Do you have a lot of surface agitation?
Also, when I had my 3" Kole Tang in my RSM (36" across), he could swim across the tank in about half a second with no effort, and did so nearly...
30 x 18 x 24 != a 4 foot tank
You just want to get surface agitation, so you can't see the tank clearly from above, if you go with his advice. But that's not what's wrong. pH...
That was the problem. The height of the outer box relative to the inner box was keeping this thing from opening up. It can now do (at least) 160...
The Kole is much smaller than a regal, and a decent amount smaller than a yellow. I don't agree on the assessment, though. I wouldn't put a tang in...
Were you pouring beer in the tank again? Seriously, it's lookin good!
Even with 2 U tubes (the right angles 5/8", and the 3/4"), it ends up giving a max flow that's about equal to 180 GPH; just the numbers from before...
You mean, does the water inside the pot rise until it's flowing over the teeth instead of through them? The thing about the other overflows is...
The teeth are (not evenly spaced, used a dremel to cut them with the router attachment) about 1/8th of an inch apart, and I cut them using the 1/8th...
I can't see that clearly enough, except to make out that the proportions are pretty off. I'm going to take a pic or two of the actual setup in a...
There's no kink in the tubing. The outside box level is about 1 inch under the inside water level when it's running.
I'm using 3/4" ID vinyl tubing for the bigger tube. I just realized that's different from the typical U Tubes because they're usually a solid piece...
I had been starting it by putting airline tube into it then sucking out the air. There's no air when I start the flow. I'm talking about when a...
Most aren't bad. They'll just eat detritus, and are good as part of the CUC. Then, there's the ones that get gigantic. The fireworms are pretty bad.
Bubbles are hardly being pulled out of the tube with the 3/4" ID tubing; I wouldn't want to go bigger because at this flow rate with this pipe, I'm...
It's gravity fed. It's an inch of water over the inner box. There's no "height it has to drop"; this is an overflow box, and I'm worried about the U...
Separate names with a comma.