Any DIY LED stands for a 28g nanocube?

I used PVC to make a little stand for my heat sink over my pico. It works, but I wouldnt recommend it for anything larger than a pico.

On my nano, I put shelf arms on the wall which had an arm to hold a rod. Thrn hung the fixture from the rod. It looks good IMO and if you put a shelf on top, it doesn't look like it is there just to hold your fixture.

 

here is the one i built. works awesome! super sturdy.

The wire hangers from the light go up through the 2 center pvc pieces then run along the top length to the opposite side where they are attached to a bolt that goes through the pvc. so you can adjust height by placement of this bolt.