Bean Animal Plumbing Support

So, I'm working on my first saltwater tank, 75 gallon. I drilled the tank last Saturday, two 3/4" returns in the upper corners, and three 1" bulkheads for the Bean Animal overflow, a little left of center.

At the back of the overflows it goes into the 1.5" sanitary tee, with the caps on top, two normal, and one with the 1/4" JG fitting tapped and installed. Underneath I have plumbing brought back down to 1", it drops about 10" or so, 45's towards the sump, then 45's down into the sump.

My question is this:
I have read that the plumbing needs to be supported by something other than the bulkheads. How do you guys/gals do it? I have searched and haven't found much info. Maybe I ought to start my own build thread. ;D

Jason

 

Anything from simple plywood supports to elaborate acrylic pieces can be used. Could even use just regular pipe clamps found at your local hardware store. Here's what I'm talking about on HD's site. http://www.homedepot.com/h_d1/N-5yc...oreId=10051&superSkuId=202891052#.UQlm4Wfq3VE


Holy freaking long link. yeesh.

 

I do belive you should start a build thread. ;D

 

Agreed. build thread is mandatory!