Meanwell SVR2 broke

Discussion in 'I made this!' started by merr3129, May 29, 2011.

to remove this notice and enjoy 3reef content with less ads. 3reef membership is free.

  1. merr3129

    merr3129 Plankton

    Joined:
    Feb 15, 2011
    Messages:
    10
    Location:
    Rochester, MI
    Hello,

    I'm in the middle of putting together the 24 Ultra Premium LED DIY Kit with Dimmable Drivers from Rapid LED and turning the SVR2 screw has no effect on the output. Is there a way to limit this outside of the driver? If I ran a 5v signal would that cut the maximum amp in half?

    Sorry for the bad quality in the picture. I used my phone to take it.

    Thanks,
    David
     

    Attached Files:

    merr3129, May 29, 2011
    merr3129, May 29, 2011
    #1

    2. Click Here!

  2. 2in10

    2in10 Super Moderator

    Joined:
    Aug 6, 2009
    Messages:
    19,258
    Location:
    Sparks, NV
    Not sure about it. I would contact Rapid about that.
     
    2in10, May 29, 2011
    2in10, May 29, 2011
    #2
  3. Leeroy Jenkins

    Leeroy Jenkins Plankton

    Joined:
    May 14, 2011
    Messages:
    24
    Location:
    Kentucky
    Did your other driver work ok? I'm just asking so the possibility of having the multimeter connected wrong can be ruled out. I believe it's connected in line to test the current.

    If not, just email them, I bet even over the weekend you'd get an answer from one of them.
     
    Leeroy Jenkins, May 29, 2011
    Leeroy Jenkins, May 29, 2011
    #3
  4. merr3129

    merr3129 Plankton

    Joined:
    Feb 15, 2011
    Messages:
    10
    Location:
    Rochester, MI
    Well, it turned out to be my mistake. I was turning the screw next to SVR2. I got everything together now and am just fine tuning it.

    Also, I emailed rapid yesterday and they responded back within a hour. Great customer service.
     
    merr3129, May 30, 2011
    merr3129, May 30, 2011
    #4