Rapid LED PWM Controller HELP!

So I am at the very last step of my install and I am at a wall here...

On Page 3 you will see a wiring diagram.. Why in the world are RED & BLACK wired together?! I don't want to blow anything when I turn it on...

http://www.vinnymarini.com/pictures/rapid_docs/DDC-01 Manual.pdf


Shouldn't it look like this?





Thanks for the help

 

Anyone?

 

?????

 

I'm sure on their site there is another page that shows how to hook everything up. I just built mine a few months ago but I really don't think that was the instructions I use. I know for sure there are three different sets of instructions. I would go look at my set but it's in the bedroom and my wife is asleep. I'll keep digging online to see if I can help. But I do agree that black shouldn't go to red in theory, not sure what is up with that pick.

 

Thanks!!! I have been looking all over and I really don't want to blow out my LEDs.

 

Meanwell Power Supply Products

Try this page here its a schematic and shows what goes where.

 

Blue wire= DIM+
White= DIM-
Red=+V
Black=-V

 

Thanks but thats a little above me.. You mentioned you have a kit.. How did you hook yours up?

 

I believe they only used black wire and that is why it shows a red to black connection (this is what I did also). You connected everything in series? Then switched to red wire after the last LED (or before the first if you are going from the other end)?

 

gonna pm you