Tank level but crown in board causing really small gap

Hey guys and gals so I built my stand yesterday and it is dead level. However when I set my new tank in place I noticed a gap under the one corner. After some further checking, I was able to determine that it is being caused by a slight crown in one of the 2x6. the gap is about 1/16 of an inch.

So first should I be concerned? And second- can I shim under the tank to correct it or should I pullnthe tank off and plane it down? Help!! Need to get my fish back in ASAP. Thanks!!

 

Is that before you put water in? I would sand it until the tank is flush.

 

Yes, no water in yet

 

I imagine any "issues" with a stand will only be exacerbated by the added weight of water/sand/rock. Any potential "tank crasher" should be addressed or you could be making a new "My New Substrate is my Carpet" thread. Not worth it to me Good luck.

 

You are both right.. I should not ask questions that I already know the answer to. Will take me 1/2 hour to correct. With all the work I have already done it's nothing.. Here is the thread to the tank build.

http://www.3reef.com/forums/show-off-your-fish-tanks/remickjs-200-gallon-tank-build-121021.html

Thanks again!